FAG tools for mechanical mounting and dismounting of rolling ...
FAG tools for mechanical mounting and dismounting of rolling ...
FAG tools for mechanical mounting and dismounting of rolling ...
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CORPORACION BASCO SACAv. Argentina 1165 - LimaTelef.: 433-6633 / 433-6834 - Fax: 431-3188E-mail: ventas@basco.com.pe<strong>FAG</strong> <strong>tools</strong> <strong>for</strong> dis<strong>mounting</strong> <strong>of</strong> <strong>rolling</strong> bearingsMechanical special bearing extractors 64 <strong>for</strong> small bearings<strong>FAG</strong> special bearingextractors 64Application• For radial bearings (deep grooveball bearings <strong>and</strong> self-aligningball bearings as well as cylindricalroller, tapered roller <strong>and</strong> sphericalroller bearings). Since the number<strong>of</strong> <strong>rolling</strong> elements is notst<strong>and</strong>ardised, different grippersmay be required <strong>for</strong> the samebearing sizes from differentmanufacturers. The bearingmanufacturer must be specifiedwhen ordering.• For tight fit <strong>of</strong> inner ring or outer ring.• For cases in which the inner ringis adjacent to a shaft shoulderwithout extraction slots, <strong>and</strong> alsowhere the bearing to be extractedfrom the shaft is still inside ahousing.• Extraction without damage ispossible with proper h<strong>and</strong>ling.• Max. shaft diameter 75 mm.lLL + ExtensionOperation <strong>and</strong> h<strong>and</strong>lingThe special extractor consists <strong>of</strong> abasic unit <strong>and</strong> a gripper, which isscrewed onto the upper section <strong>of</strong>the basic unit. The gripper is closedusing the left h<strong>and</strong> thread <strong>of</strong> theunion nut <strong>and</strong> clamped against theinner ring with a conical clampingring. A threaded spindle generatesthe extraction <strong>for</strong>ce.The finger-shaped extensions <strong>of</strong> thegripper engage between the <strong>rolling</strong>elements on the raceway edge <strong>of</strong>the inner ring, behind the rollers orbehind the chamfer <strong>of</strong> the bearingring, wedging it loose. The extractionprinciple must be observed whenselecting the suitable gripper <strong>for</strong>the respective bearing, see page 25.ØDProduct range - special bearing extractors 64ØdOrdering designationBasic unit <strong>for</strong>Dimensions SpindlethreadMassWspecial extractor d D l LmmkgPULLER64-400 30,5 60 78 135 M14~1,5 1,25PULLER64-500 46 75 80 150 M20~2 2,5PULLER64-600 66 100 92 170 M22~2 3,8PULLER64-700 77 126 120 205 M30~2 7,8The basic unit is selected such that the dimension d is greater than thebearing bore, <strong>for</strong> example PULLER64-700 (d = 77 mm) <strong>for</strong> <strong>rolling</strong> bearing 6015with 75 mm bore.24