Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

More documents

Recommendations

Info

$+HDY\ 7ZLQ 6HULHV Clamp Body Æ 3UR OHG 'HVLJQ ... - Stauff$

$+HDY\ 6DGGOHV DIN 1592 Dimensions / Order Codes + ... - Stauff$

5.0 Connecting the sensors / Display functionsTo avoid electrical interference, please observe the following steps:1 Connect the sensor to the measuring instrument using the connection cable.2 Turn on the measuring instrument.11-30VDC I1 I2 I3I4®PCPPC-06-plusON/OFFZEROIN1=IN2STOPRECESCOKMEMSETDISPLINERESETMIN/MAXMeasuring instrument with two pressure sensors• Once turned on, all measured values are visible in the display.• Automatic sensor recognition ensures that the measured value is indicated in thecorrect unit.• No further settings to the device are required.• The following message will be displayed if no sensor is connected to the device.12
5.1. Display format (DISP)Press DISP (once)It is possible to change the display format bypressing DISP (once only).Available selection:ACT = Actual valuesMIN = Minimum valuesMAX = Maximum values (pressure spikes)FS = Full scale (upper range value)TEMP = Temperature displayThe TEMP display applies only to the sensor type PPC-04/12-PT.13
Page 2 and 3: Contact addressWalter Stauffenberg
Page 4 and 5: 10.0 Setting and operating via PC..
Page 6 and 7: MountingPlease abide by the instruc
Page 8: 3.0 Initial useThe measuring instru
Page 11: 4.3. Symbols and using the menusIf
Page 15 and 16: 5.3. Zero Point Calibration (ZERO)I
Page 17 and 18: 5.6. Differential value alignment (
Page 19 and 20: 5.7. Connecting auxiliary sensors (
Page 21 and 22: 5.8. Error messages / WarningsDispl
Page 23 and 24: 6.1. Setting the units (SET-UNIT)Av
Page 25 and 26: 6.6. Setting the time / date (SET-T
Page 27 and 28: Example:No dynamic MIN-MAX values a
Page 29: 8.0 The REC menu29
Page 32 and 33: 9.2. The REC NAMES settingDesignati
Page 34 and 35: The following message is displayed:
Page 36 and 37: The data format FAST (recording int
Page 38 and 39: If conflicts arise between the reco
Page 40 and 41: If conflicts arise between the reco
Page 42 and 43: 10.0 Setting and operating via PC10
Page 44 and 45: 12.0 Technical DataSensor inputSens
Page 46 and 47: 1. Determining the number of the me
Page 48 and 49: 1. Determining the duration of the

Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?