Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

More documents

Recommendations

Info

$+HDY\ 7ZLQ 6HULHV Clamp Body Æ 3UR OHG 'HVLJQ ... - Stauff$

$+HDY\ 6DGGOHV DIN 1592 Dimensions / Order Codes + ... - Stauff$

5.2. Display Configuration (LINE)Press and hold (2 seconds)Line:1: No settings possible; cannot be selected2: Available for selection:Difference (IN1 – IN2)Addition (IN1 + IN2)3: Volume VOL = Q3 x time4: Available for selectionPowerPWR1 = p1 x Q3PWR2 = (p1-p2) x Q314
5.3. Zero Point Calibration (ZERO)If the alignment values are within thepermissible tolerance (2% of FS),the values are set to zero.If the alignment values exceed thepermissible tolerance (2% of FS), thefollowing is displayed: "ZERO OFL"Press ZERO once15
Page 2 and 3: Contact addressWalter Stauffenberg
Page 4 and 5: 10.0 Setting and operating via PC..
Page 6 and 7: MountingPlease abide by the instruc
Page 8: 3.0 Initial useThe measuring instru
Page 11 and 12: 4.3. Symbols and using the menusIf
Page 13: 5.1. Display format (DISP)Press DIS
Page 17 and 18: 5.6. Differential value alignment (
Page 19 and 20: 5.7. Connecting auxiliary sensors (
Page 21 and 22: 5.8. Error messages / WarningsDispl
Page 23 and 24: 6.1. Setting the units (SET-UNIT)Av
Page 25 and 26: 6.6. Setting the time / date (SET-T
Page 27 and 28: Example:No dynamic MIN-MAX values a
Page 29: 8.0 The REC menu29
Page 32 and 33: 9.2. The REC NAMES settingDesignati
Page 34 and 35: The following message is displayed:
Page 36 and 37: The data format FAST (recording int
Page 38 and 39: If conflicts arise between the reco
Page 40 and 41: If conflicts arise between the reco
Page 42 and 43: 10.0 Setting and operating via PC10
Page 44 and 45: 12.0 Technical DataSensor inputSens
Page 46 and 47: 1. Determining the number of the me
Page 48 and 49: 1. Determining the duration of the

Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?