Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

More documents

Recommendations

Info

$+HDY\ 7ZLQ 6HULHV Clamp Body Æ 3UR OHG 'HVLJQ ... - Stauff$

$+HDY\ 6DGGOHV DIN 1592 Dimensions / Order Codes + ... - Stauff$

5.4. Deleting MIN / MAX values (RESET)The MAX values measured until now are displayedin the MAX displayDeleting MAX valuesThe updated MAX values are displayed in the MAXdisplay.Example: Loss of pressure in the hydraulic system.5.5. Difference for measuring values►The settings IN1 – IN2 are described in the chapter "Display configuration (LINE)"16
5.6. Differential value alignment (IN1=IN2)Befor running the differential value alignment of two sensors of the same type it is necessaryto run a configuration first.Herefor follow the instructions in chapter 5.2 and calculate the difference of both sensors.Press and hold (2 seconds)Carry out differential value alignment at below operating pressure. Connect twopressure sensors to the same connection (T-adapter). Δp-calibration sets thetolerance of the sensors in relation to one another to zero.This setting remains stored; it is valid only for the respective operating pressure.17
Page 2 and 3: Contact addressWalter Stauffenberg
Page 4 and 5: 10.0 Setting and operating via PC..
Page 6 and 7: MountingPlease abide by the instruc
Page 8: 3.0 Initial useThe measuring instru
Page 11 and 12: 4.3. Symbols and using the menusIf
Page 13 and 14: 5.1. Display format (DISP)Press DIS
Page 15: 5.3. Zero Point Calibration (ZERO)I
Page 19 and 20: 5.7. Connecting auxiliary sensors (
Page 21 and 22: 5.8. Error messages / WarningsDispl
Page 23 and 24: 6.1. Setting the units (SET-UNIT)Av
Page 25 and 26: 6.6. Setting the time / date (SET-T
Page 27 and 28: Example:No dynamic MIN-MAX values a
Page 29: 8.0 The REC menu29
Page 32 and 33: 9.2. The REC NAMES settingDesignati
Page 34 and 35: The following message is displayed:
Page 36 and 37: The data format FAST (recording int
Page 38 and 39: If conflicts arise between the reco
Page 40 and 41: If conflicts arise between the reco
Page 42 and 43: 10.0 Setting and operating via PC10
Page 44 and 45: 12.0 Technical DataSensor inputSens
Page 46 and 47: 1. Determining the number of the me
Page 48 and 49: 1. Determining the duration of the

Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

Create successful ePaper yourself

Delete template?

Save as template?