Operating Instructions PPC-06/08-Plus v2009 (PDF - 1,3 MB) - Stauff

9.7. Recording measured values with default PROJECT settingsIn this setting, measurements are made using a defined sensor configuration. The user usingthe PC software defines this configuration. This avoids false measurements and wrongsettings.The preset parameters are altered in the PC software and transferred to the measuringinstrument.The following parameters can be set:MenuREC NAME>Setting/Pre-selectionNo1 ... 5ExampleNotesLoad Test There are max. 5 predefinedsettings (tests) available forselectionINPUT> PILOT PRS Defined sensors are defined foreach channelWRONGSENSOR!CORRECTSENSOR!USE 150 bar Warns of wrong sensor:A pressure sensor with thecorresponding FS (full scale) mustbe connected to this channelFS 600 l/min Indicates correct sensor.The next channel can beconnected.When all of the sensors are connected, the respective type of recording (START/STOP,POINT, AUTO TRIGGER, MANUAL) is selected and performed automatically. An internalquery of the connected sensors occurs only before choosing the project setting.41