FD-5 - Tams

More documents

Recommendations

Info

English<strong>FD</strong>-5Technical specificationsData formatSupply voltageCurrent consumption(without connected loads)Max. current per function outputMax. total currentDCC12-24 Volt digital voltageca. 10 mA500 mA1.500 mAProtected to IP 00Ambient temperature in useAmbient temperature in storage0 - + 60° C-10 - + 80° CComparative humidity allowed max. 85 %DimensionsWeightca. 12,5 x 27,5 x 3,5 mmca. 2 gChecking the package contentsCheck the contents of the package for completeness:• 1 module• 1 manualRequired tools and consumablesMake sure you have the following tools, equipment and materials readyfor use:• a heat-resistant mat• a soldering iron stand with tip-cleaning sponge• a small side cutter and wire stripper• an electronic soldering iron (max. 30 Watt) with a fine tip• tin solder (0,5 mm. diameter)• wire (diameter: > 0,08 mm² for all connections)Page 24
<strong>FD</strong>-5EnglishSafe and correct soldering!Caution:Incorrect soldering can cause fires (through excessive heat). Avoid thisdager by reading the chapter Safety instructions again and followingthe directions given.If you have had training in soldering you can skip this chapter.• When soldering electronic circuits never use soldering-water orsoldering grease. They contain acids that can corrode componentsand copper tracks.• Only use tin solder SN 60 Pb (i.e. 60 % tin, 40 % lead) with rosinbasedflux.• Use a small soldering iron with max. 30 Watt. Keep the soldering tipclean so the heat of the soldering iron is applied to the solder pointeffectively.• Solder fast: long soldering can destroy components and coppertracks, and damages through plated holes.• Apply the soldering tip to the soldering spot in such a way that the partand the soldering spot are heated at the same time. Simultaneouslyadd solder (not too much). As soon as the solder becomes liquid take itaway. Hold the soldering tip at the spot for a few seconds so that thetin solder finds its way, then remove the soldering iron.• Do not move the component for about 5 seconds after soldering. Aglossy and perfect soldering spot should remain.• To make a good soldering joint you must use a clean andunoxidised soldering tip. Clean the soldering tip with a damp pieceof cloth, a damp sponge or a piece of silicon cloth.Performing a visual checkDamaged materials can cause injury. Parts damaged during transit canalso be dangerous. Check the module for damage, missing parts orpoor soldering. If you find damage, return the module for exchange.Page 25
Page 1 and 2: •FD-4 • •FunktionsdecoderMoto
Page 3 and 4: FD-5EnglishTable of contentsHow to
Page 5 and 6: FD-5EnglishSafety instructionsMecha
Page 7 and 8: FD-5EnglishEMC declarationThis prod
Page 9: FD-5EnglishFunction F2The function
Page 13 and 14: FD-5English! Caution:The return con
Page 15 and 16: FD-5EnglishFAQ• Parts are getting
Page 17 and 18: FD-5FD-5Anschlußplan - Connections
Page 19: •••Aktuelle Informationen und

FD-5 - Tams

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?