FD-5 - Tams

More documents

Recommendations

Info

English<strong>FD</strong>-5Programming the function decoderThe function decoder is programmed from the digtial control unit. Seechapter in the manual of your digital control unit where theprogramming of configuration variables (CVs) is explained.You can programm the following function decoder variables:CV-NameEingabewert(Auslieferungszustand)BasicaddressConsistaddressConfigurationdataUtilizationand settingof outputX9 and X10Page 28CV-Nr.1 1 ... 127(3)19 1 ... 127(0)29 0,1,2 or 3(2)56 0,1,2 or 3(3)Erläuterungen= 2nd addressThis data is set by entering thesum of the numerical values.Numerical valuedirection "standard" 0invert direction 114 speed levels 028 speed levels 2This data is set by entering thesum of the numerical values.Numerical valueConstant lighting 0Lighting accordingto direction of travel 1Optional accessoryswitched via F4 0Lighting forreverse direction 2
<strong>FD</strong>-5EnglishFAQ• Parts are getting too hot and/or start to smoke.! Disconnect the module from the mains immediately!Possible cause: Short circuit. The decoder is connected tolocomotive or carriage ground.à Check the connections. A short circuit can result in irreparabledamage.• The lighting does not correspond to the direction of travel.Possible cause: The configuration data (CV29) of the locomotivedecoder in the train vary from the configuration data programmedin the function decoder.à Change the programming or the function or the locomotivedeocder.• The lighting for forward dirction cannot be switched via F0.Possible cause: The speed mode of the decoder and the digitalcontrol unit do not correspond. Example: The control unit is set tothe mode 28 speed levels, but the decoder to the mode 14 speedlevels.à Change the speed mode at the control unti and / or at thedecoder.If you cannot find the problem, please return the decoder for repair(address on the cover page).Manufacturer's noteAccording to DIN VDE 0869, the person who builds this kit or brings thecircuit into operation is the manufacturer of the product. If he sells theproduct to another person he is responsible for passing on all therelevant papers. Domestic appliances assembled from a kit are deemedindustrial products and must comply with health and safety regulations.Page 29
Page 1 and 2: •FD-4 • •FunktionsdecoderMoto
Page 3 and 4: FD-5EnglishTable of contentsHow to
Page 5 and 6: FD-5EnglishSafety instructionsMecha
Page 7 and 8: FD-5EnglishEMC declarationThis prod
Page 9 and 10: FD-5EnglishFunction F2The function
Page 11 and 12: FD-5EnglishSafe and correct solderi
Page 13: FD-5English! Caution:The return con
Page 17 and 18: FD-5FD-5Anschlußplan - Connections
Page 19: •••Aktuelle Informationen und

FD-5 - Tams

Create successful ePaper yourself

Delete template?

Save as template?