5600SE Downflow - V2.0

Master Programming Mode5600SE Downflow - V2.0Set Up buttonExtra Cycle buttonSet Down buttonWhen the Master Programming Mode is entered, all available option setting displays may be viewed and set as needed. Dependingon current option settings, some displays cannot be viewed or set.Entering Master Programming ModeSet the Time Of Day display to 12:01 P.M. Push and hold the Set Up and Set Down buttons together until the Program Dotturns on (about 5 seconds). Depending on current option settings, some displays cannot be viewed or set.Exiting Master Programming ModePush the Extra Cycle button once per display until all are viewed. The Program Mode is exited and normal operation resumes.Resetting Permanent Programming MemoryPush and hold the Set Up and Set Down buttons for 25 seconds or until the Time Of Day display resets to 12:00 P.M. Alloption settings reset to default values. Control programming must be reset as necessary.1. US/Metric Display Format (U)Push the Extra Cycle button. This display is used to set the desired display format. This option setting is identified by the "U"in the first digit. The possible settings are:US Format uses gallons for volume with a 12-hour timekeeping format. Regeneration timing in minutes.Example: [U - - I]Metric Format uses liters for volume and a 24-hour timekeeping format. Regeneration timing in tenths of minutes. Use theSet Up and Set Down buttons to adjust this value.Example: [U - - 2]Cubic Meter Format uses cubic meters for volume and a 24-hour timekeeping format. Regeneration timing in tenths ofminutes. Use the Set Up and Set Down buttons to adjust this value.Example: [U - - 4]Printed in U.S.A.Page 3