69-1849 - PRO 4110D Programmable Thermostat - Honeywell

Installation GuideInstaller setupFollow the procedure below to configure the thermostat to match the installedheating/cooling system, and customize feature operation as desired.Press and hold both buttonsFunctionnumberSettingSetup1 0To begin, press and hold the andbuttons until the display changesPress to change settingsPress to advance to next functionPress and hold to exit and save settingsSetup Function159System typeHeating cycle rate(CPH: cycles/hour)Compressorcycle rate (CPH)Settings & Options0 Gas, oil or electric heat with air conditioning1 Heat pump (5 minute compressor off time in heating and cooling)5 For gas or oil furnaces of less than 90% efficiency1 For steam or gravity systems3 For hot water systems & furnaces of over 90% efficiency9 For electric furnaces[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]3 Recommended for most compressors[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]131415Adaptive IntelligentRecoveryTemperaturedisplayCompressorprotection1 On **See page 100 Off0 Fahrenheit1 Celsius5 Five-minute compressor off time **See page 10[Other options: 0, 1, 2, 3 or 4-minute off time]Installer system testAfter completing the installer setup above, press thesystem test (see next page).button again to begin a8