69-1849 - PRO 4110D Programmable Thermostat - Honeywell

More documents

Recommendations

Info

Installation GuidePre-installation checklistPackage contentsCheck to make sure your package includes the following items:• PRO TH4110D digital thermostat (wallplate attached to back)• Operating manual• Wall anchors and mounting screws (2 each)• AA alkaline batteries (2)• Quick reference cardRequired tools & supplies• No. 2 Phillips screwdriver• Small pocket screwdriver• Drill• Drill bit (3/16” for drywall, 7/32” for plaster)• Hammer• Pencil• Electrical tape• Level (optional)2
PRO TH4110D Programmable ThermostatWallplate installationGrasp top and bottom of wallplateand pull to remove from thermostat.Remove the wallplate from the thermostatas shown at left, then followdirections below for mounting.1 Pull wires through wire hole.2 Position wallplate on wall, level andmark hole positions with pencil.3 Drill holes at marked positions asshown below, then tap in suppliedwall anchors.4 Place wallplate over anchors, insertand tighten mounting screws.5 Insert quick reference card in slotin front of wall plate.Insert quick reference card afterwallplate is mounted (see mountinginstructions, below)Drill 3/16” holes for drywall.Drill 7/32” holes for plaster.Wire holeMounting screwsWall anchors3
Page 1 and 2: InstallationGuideTH4110DProgrammabl
Page 3: PRO TH4110D Programmable Thermostat
Page 7 and 8: PRO TH4110D Programmable Thermostat

69-1849 - PRO 4110D Programmable Thermostat - Honeywell

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?