4-3 REMOVAL AND INSPECTION OF ... - Mojo Motorcycles

More documents

Recommendations

Info

4-4 Removal and Installation of body4-4-1 Removal and Installation of Seatand CoverSeat:◎ Remove the nuts and pin.◎ Seat.◎ Remove 6 bolts on the helmet case.◎ Helmet case.Note:There is a coupler under the helmet case.And remove it.Additions of side cover:◎ Remove the handles.◎ Remove the bolts on the side cover.Leg shield:◎ Remove the bolts on the leg shield.(each side)◎ leg shield.Installation:Install in reverse order of removal procedures.206PDF created with pdfFactory Pro trial version www.pdffactory.com
Front fender:◎ Remove the bolts on the front fender.(each side)Mud guard:◎ Remove the bolts on the mud guard.(each side)125c.c.250c.c.Raer leg shield:◎ Remove the bolts on the rearleg shield.(each side)Installation:Install in reverse order of removal procedures.207PDF created with pdfFactory Pro trial version www.pdffactory.com
Page 1 and 2: 4-3 REMOVAL AND INSPECTION OF ELECT
Page 3 and 4: Too low capacity:1. Insufficient re
Page 5 and 6: 4-3-2 BATTERYA. Cautions in battery
Page 7: 4-3-5 RESISTORDisassembly: Remove f
Page 11 and 12: Wind shield:◎ Remove the bolts on
Page 13 and 14: CU8 & CUB:◎ Remove upper and lowe
Page 15 and 16: Inspection: Check if the shock abso
Page 17 and 18: CU8-B & CUB-B213541365241:MASTER CY
Page 19: . Make sure the brake cam runs smoo

4-3 REMOVAL AND INSPECTION OF ... - Mojo Motorcycles

Create successful ePaper yourself

Delete template?

Save as template?