Corrigendum 01 of Tender 05 of 2013

24 Clause No 5.3 Up and over capability of approx. 12 m isrequired25 Clause No 5.5 The first boom shall be able to elevate inthe range of -3 degree to +85 degree.26 Clause No 9.1 All jacks and horizontal beams shall behot-dip galvanized for better corrosionprotection.27 Clause No 9.3 Each wheel shall be provided with offgroundsensors28 Clause No 9.2 The stabilizing system shall alsoincorporate axle-locking mechanismthe required outreach is available in F55 RLXunit. Do you have any objections to this?In F55 RLX it is 10.5 meters. This is due todifferent boom designs of differentmanufacturers. Please note that the BrontoF55 RLX provides much more benefitsexceeding your specifications including lighterin weight, more outreach, more cage load etc.Please accept 10.5 meters and amend.In F55 RLX this is 0 to 84 degrees. When therequired down reach is reached in F55 RLX, 6meters is achieved instead of the required 5meters, therefore the minus angle has nomeaning. According to our opinion the range ofthe 1 st boom should be deleted or changedfrom 0 to 84 degrees.Ours is paint technique for corrosionprotection. Please accept and amend.In Bronto F55 RLX, it is a built-in safetymechanism in the outrigger operation that ischecking that the wheels are off the groundand only then allowing the boom movements.The safety feature as required by you is therebut in a different way. Please accept andamend.This used to be case many years ago. But now,the axle lock is not necessary in our Bronto F55RLX units anymore. Please accept and amend.29 Clause No 9.2 Wireless remote control The wireless remote control is not installed atthe outrigger panel. Are the features 9.19.1 to9.19.6 asked to be provided in the wirelessremote control or on the outrigger panel?There is a separate radio remote control foroutrigger with 20 meter range if required byyou. Please see attached. We do provide 100meters range Radio remote control for allboom and water monitor movements. Pleaseclarify.Up and over capabilityspecified is approx. 12m which means weallow +/- 10 %.The first boom shall beable to elevate in suchway and angle that itshall allow to raise acage upto the height of53 mtrs (upto cagebottom) and also thedown reach of the cageshall be nor less than 5mtrs. Preferably theangle of first boom shallbe between -3 to +85degree.All jacks and horizontalbeams shall be hot-dipgalvanized or shotblasted for bettercorrosion protectionbefore painting.Each wheel shall beprovided with offgroundsensors or thejack legs shall haveground pressuresensors and systemshould not allow to liftthe booms unless thereis enough groundpressure on jacks andvehicle is correctlylevelled.The stabilizing systemshall also incorporateaxle-locking mechanismif required.No Change