XRAY T2R PRO Instruction Manual

8. FINAL ASSEMBLY902306SH M3x6When installing the motor on the bulkhead, rotate the spur gear so the motor screw can be installed througha hole in the spur gear. See the detail image below.Adjust the motor so the pinion meshes with the spur gear properly. Make sure the gear mesh is not too tight.There should be a small amount of play between the teeth of the pinion gear and spur gear.DETAILSuggested to use3x2.5mm set screwPINION(NOT INCLUDED)GEARING ADJUSTMENTMOTOR(NOT INCLUDED)RECEIVER(NOT INCLUDED)903308SFH M3x8SPEED CONTROLLER(NOT INCLUDED)DOUBLE-SIDED TAPE(NOT INCLUDED)Feed the receiver wire into the antenna tubeBATTERY ASSEMBLY CONFIGURATION6-CELL ALTERNATIVE903306SFH M3x6903308SFH M3x83x8mm3x6mm3x8mm3x6mm27