Xcavator Instruction Manual - Whip Mix

Xcavator Operating InstructionsStep By Step Directions For Use (continued)Step 9Position the Depth of Cut Selector knob to thepre‐determined position for the type of investmentand the concentration of the mix for the specificmold you just put in the Xcavator (Figure 8).Step 10 Press the Delay button corresponding to themold size you just put in the Xcavator. You cango about other duties until the Xcavator beepsand the Ready LED lights (Figure 9).NOTE: If the mold has cooled naturally formore than 10 minutes you can bypass the timedelay function by pressing the “Active” buttonfor the given ring mass and the divesting cyclewill start immediately.Figure 8CAUTION: DO NOT OPEN THE CABINET DOOR UNTILTHE READY LIGHT TURNS GREEN AND THE BEEPERBEEPS. OPENING THE CABINET PREMATURELY(BEFORE THE BEEPER) CAN ALLOW HAZARDOUSDUST PARTICLES TO ESCAPE INTO THE room.Step 11 Open the door and remove the 95% divested moldby hand, as it will now be cool enough to handlesafely with your bare hand (Figures 10).Step 12 Use your manual divester briefly, if necessary, toremove any material “shadowed” by the spruearms or inside the hollows of the copings.Figure 9Figure 109