Digi-Troll IV Manual - Cannon Downriggers

Terminating the Downrigger CableRubber CushionCableTip: A set of pliers with wire cutters isrecommended for this part of setup.Lead cable intoHOLE A.Pull six inches ofcable through.Thread cablethrough swivel,then up intobottom of theterminator.Lead cable out ofHOLE B and intoHOLE C. Push thecable until its endtouches the insideof the terminatorhook.Unwind about 2 feet of cableand thread the cable throughthe rubber cushion.Snap &SwivelTIP: Use only straight cable, not kinked.HOLE ATighten cableby squeezingterminatoruntil it snapsshut. Thenpull at top andbottom untildrawn tight.Make surethat the cablethreads thehook.SwivelAttach to terminator.Examine the top of the terminator and note theorder shown in the detail to run cable.CABLE INCABLE INCABLE OUTSlide the cushion over the top of theterminator and give it a test pull.The cable is set to attach a CannonTrolling Weight.TERMINATOR & LINE RELEASECannon Uni-ReleaseThe Cannon Uni-Release attaches directly tothe downrigger weight. Attach fishing line to theclip at the end of the release, and then clickthrough a series of increasing tension settings.The release can be used with any test line on saltor fresh water and may be adjusted from 2 to 22pounds of grip tension on the line.CloseOpenTensionAdjustFishing LineTo change line release tension, turn tensionknob to (+) to increase or (-) to decrease. Tensionalso may vary according to where the line isplaced in the grips. Higher tension is on the line ifit is set back toward the hinge, and lower if setcloser to the opening. To open the release, spreadthe release arms with thumb and forefingerapplying pressure to the sides.OpenGripperPads7