Digi-Troll IV Manual - Cannon Downriggers

ATTACHING THE ROD HOLDERAttaching the Rod HolderThe positive lock rod holder incorporates alocking disk that allows the rod holder to bealigned in 15 degree increments. Slide the rodholder tube into the clamp to the desired positionwithin the recommended area (see below). Besure the angled shoulders are facing up. Placethe locking disk into the mating recess of theframe. Slip the clamp arms in place where theobround tab on the disk fits into the slot on theclamp. Slide the star washer between the arm ofthe clamp and the frame. Place the flat washeronto the bolt. Then insert the bolt with washerthrough the clamp by entering the disk, goingthrough the frame, the star washer, and out theother side of the clamp. Tighten the nut tosecure the rod holder. Reposition the rod holderby loosening the nut and adjusting the tilt.CAUTION: This rod holder is intended for useof up to 30 lb. test line only, and is notrecommended for use with any tackle IGFArated higher than 30 lb. A safety strap (notincluded) is recommended for all applications.The rod holder assembly is not warrantedwhen used with tackle above 30 lbs.Equipment placed in the rod holders and theloss thereof is the responsibility of the userand is in no way warranted by JOHNSONOUTDOORS, INC. Mounting must be inaccordance with the above instructions anddiagram to be warranted.Single Rod Holder AssemblyDual Rod Holder AssemblyRecommendedArea to ClampRod HolderStar WasherPlacementAngledShoulder8