Appendix E - Technical Specifications for Drilling Operation.pdf

More documents

Recommendations

Info

EnviroLogic Resources, Inc.7.0 HEALTH AND SAFETYThe Contractor shall be responsible for the health and safety of any and all of his employees who areunder his direction during this project, including his subcontractors. The Contractor shall becomefamiliar with, and abide by, the site-specific Health and Safety Plan (Appendix C). The Contractor shallbe responsible for fitting his employees and his subcontractor’s employees for half-faced respiratorsprior to commencement of field work and shall be responsible for having properly fitted respiratorsavailable throughout the project. The Contractor shall be responsible for health and safety training of hisemployees and his subcontractor’s employees as specified in Occupational Safety and HealthAdministration, 29 CFR Part 1910.120, Hazardous Waste Operations and Emergency Response, FinalRule.Contractor and subcontractor employees shall, whenever directed by the consultant, wear face-fittedrespirators. Refusal to wear respirators at the direction of the consultant shall constitute grounds fordismissal of subcontractors by the consultant and/or termination of the Contractor.19
EnviroLogic Resources, Inc.8.0 WASTE HANDLINGThis section addresses the issues of handling of cuttings and residual water and site cleanup. Each ofthese issues is discussed below.8.1 HANDLING OF CUTTINGS AND RESIDUAL WATERThe Contractor shall be responsible for depositing all cuttings, formation water, sediment, and drillingfluid produced by drilling and decontamination operations into appropriate receptacles provided by theContractor. The Contractor shall be responsible for cleanup of any spilled water or cuttings, and anydamage caused by such spillage. Handling of IDW will be conducted as described in the RI/FS WorkPlan.8.2 SITE CLEANUPUpon completion of the work at each drilling location or in case of any earlier termination of thecontract, the Contractor shall remove from the vicinity of each drilling location, at the Contractor’s solecost and expense, all unused materials belonging to the Contractor or used under the Contractor’sdirection during construction and all temporary structures, rubbish, and solid waste materials resultingfrom their drilling operation. The Contractor shall leave the premises in a neat and clean conditionwithout stains on paved areas, holes, or pitfalls. In the event of the Contractor’s failure to perform hisobligations under this paragraph, the Consultant may cause the same to be performed at the expense ofthe Contractor.The Contractor shall regularly and daily clean up the work site to maintain safety, access, and to avoidfire hazard. All scrap lumber, scrap metal, wire, or other scrap building and/or drilling materials shall beregularly hauled away at the Contractor’s expense. The Contractor shall keep the construction site neat20
Page 1 and 2: EnviroLogic Resources, Inc.APPENDIX
Page 3 and 4: EnviroLogic Resources, Inc.5.0 WELL
Page 5 and 6: EnviroLogic Resources, Inc.These co
Page 7 and 8: EnviroLogic Resources, Inc.• Stea
Page 9 and 10: EnviroLogic Resources, Inc.and the
Page 11 and 12: EnviroLogic Resources, Inc.ground s
Page 13 and 14: EnviroLogic Resources, Inc.The well
Page 15 and 16: EnviroLogic Resources, Inc.4.7.1 Ab
Page 17 and 18: EnviroLogic Resources, Inc.‣ Well
Page 19 and 20: EnviroLogic Resources, Inc.5.0 WELL
Page 21: EnviroLogic Resources, Inc.6.0 DRIL

Appendix E - Technical Specifications for Drilling Operation.pdf

Create successful ePaper yourself

Delete template?

Save as template?