PREFACE THE STRONG HIGHLIGHT II Xenon ... - Iceco.com

RECEIVING & INSTALLATIONINSPECT THE SHIPMENT immediately and report any damage to the freight carrier. Itis the responsibility of the consignee, not the shipper, to press damage claims. Strong International willprovide shipping documents upon request.MOVE THE CONSOLE on its base pallet as far as possible to its intended location. Afterremoving the console from the pallet, install the four leveling pads and level the console to the booth floor.NOTE: If the booth floor is a soft material, such as linoleum, it is advisable to obtain four 4 inch x 4 inch x1/4 inch steel plates to place under the leveling pads to prevent “settling.”THE LEVELING FEET on the console are adjustable by loosening the locknut andraising or lowering the corner by turning the stud of the leveling foot with an end wrench. Retighten thelocknut after leveling the console.EACH CONSOLE is supplied with a soundhead spacer block to correctly position theprojector aperture at the specified working distance from the center of the lamphouse reflector. The makeand model of the soundhead and projector must be specified with the original equipment order to enableStrong International to supply the correct spacer block. The correct mounting hardware is supplied with thespacer block.PROJECTOR - SOUNDHEADSPACER BLOCKMANUFACTURER PART NO.Ballantyne 71229Simplex 71231Century 71231RCA 9030 71924Cinemeccanica V5 71722Cinemeccanica V8 23809USING THE CORRECT SPACER BLOCK and the soundhead mounting bolts provided,mount the soundhead to the projector mounting arm on the front of the console. This is most easilyaccomplished by starting the top two bolts, through the washers and spacer block, into the back of thesoundhead casting. The soundhead can then be lifted into place, and the top two bolts into the soundheadcasting lowered into the slotted holes in the projector mounting arm. In this manner, the mounting arm willbear the weight of the soundhead while the two bottom bolts are started.TO AVOID CROSSTHREADING, the soundhead mounting bolts should be screwed infingertight as far as possible. Before tightening the bolts, check first the console, and then the projectormounting surface, for level.HL2/003