PREFACE THE STRONG HIGHLIGHT II Xenon ... - Iceco.com

WIRING INSTALLATIONALL INSTALLER CONNECTIONS to the Highlight II Console are made to the mainterminal board located behind the left (off-operator) door and blower panel toward the front of the unitadjacent to the xenon power supply.BECAUSE OF HIGH VOLTAGES impressed during the ignition cycle, the console must begrounded. Connect the ground wire to the grounding lug adjacent to the terminal board.THE AC REQUIREMENT for the Highlight II is a four-wire three phase line (three phaseplus neutral), with a separate earth ground. Voltage requirements are stamped onto the Name and Data Plate.All branch circuits are derived from this main input. The AC supply must be installed by a qualifiedelectrician in conformance to local codes. Hardware, wire sizes and conduit types must comply with localcodes. A readily accessible disconnect device shall be incorporated in the AC supply line to permit the operatorto turn off all power to the console if required. Installer connections include three phase “hot” connections toTerminals 1, 2, and 3; 110 volt phase to Terminals 4 & 5, and a neutral connection to Terminal 6. See theattached Installation Diagram.AUTOMATION SWITCHING LEADS connect to the (2) terminal barrier strip adjacentto the AC input terminal board. Do not apply voltage to these terminals; a sustained dry contact rated at fiveamperes is required. The LAMP switch on the lamphouse control panel is provided for manual ignitioncontrol, and to act as an override in the event of an automation failure.8"AutomationTerminalsTiltLockAC Input TerminalBoard 71933HL2/005