Instruction Manual book - Pichler

More documents

Recommendations

Info

RYAN - Item code: BH72 .<strong>Instruction</strong> <strong>Manual</strong>After installing the adjustable metal connectorapply a small drop of thin C/A tothe bottom nut. This will prevent the connectorfrom loosening during flight.Connector.Servo arm.Right sideThrottle servoLeft sidePushrod wireThrottle pushrodCOWLING.Pushrod wireINSTALLING THE THROTTLE PUSHROD. Install one adjustable metal connectorthrough the third hole out from the center ofone servo arm, enlarge the hole in the servoarm using a 2mm drill bit to accommodate theservo connector. Remove the excess materialfrom the arm. 1. Slide the fiberglass cowl over the engineand line up the back edge of the cowl withthe marks you made on the fuselage.16
RYAN - Item code: BH72.INSTRUCTION MANUAL 2. While keeping the back edge of thecowl flush with the marks, align the front ofthe cowl with the crankshaft of the engine. Thefront of the cowl should be positioned so thecrankshaft is in nearly the middle of the cowlopening. Hold the cowl firmly in place usingpieces of masking tape. 3. Slide the cowl back over the engineand secure it in place using four wood screws.See picture below. 4. Install the muffler and muffler extensiononto the engine and make the cutout in thecowl for muffler clearance. Connect the fueland pressure lines to the carburetor, mufflerand fuel filler valve.Left sideRight side3 x 12mmTrim and cut afterLeft sideMachine screw.Right side.INSTALLING THE SPINNER.Install the spinner backplate, propeller andspinner cone. The spinner cone is held inplace using two 3mm x 12mm wood screws.3 x 12mmLeft side.17
Page 1 and 2: Instruction Manual bookSPECIFICATIO
Page 3 and 4: RYAN - Item code: BH72.INSTRUCTION
Page 15: RYAN - Item code: BH72.INSTRUCTION

Instruction Manual book - Pichler

Create successful ePaper yourself

Delete template?

Save as template?