Instruction Manual book - Pichler

More documents

Recommendations

Info

RYAN - Item code: BH72 .<strong>Instruction</strong> <strong>Manual</strong>C/A glueC/A glueBottom sideBottom sideC/A glueC/A glueBottom sideBottom sideBottom sideC/A glueBottom sideBottom side 2) Using a modeling knife, remove the coveringat possition show below.RemovecoveringC/A glueBottom side4
RYAN - Item code: BH72.INSTRUCTION MANUALSecureSecure 3) Using the thread as a guide and usingmasking tape, tape the servo lead to the endof the thread: carefully pull the thread out.When you have pulled the servo lead out, removethe masking tape and the servo leadfrom the thread.Bottom side 4) Drill 1,6mm pilot holes through the blockof wood for each of the four mounting screwsprovided with the servo. 5. Instal servo tray with aileron servo intothe wing as same as picture below.Electric wireBottom side2.INSTALLING THE AILERON CONTROL HORN.3mm x 40mm.threadM3 lock nut.Nilon control clasp.2x10mm.5
Page 1 and 2: Instruction Manual bookSPECIFICATIO
Page 3: RYAN - Item code: BH72.INSTRUCTION
Page 7 and 8: RYAN - Item code: BH72.INSTRUCTION

Instruction Manual book - Pichler

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?