EFM32 Debug and Trace - AN0043 - Application Note - Energy Micro

More documents

Recommendations

Info

Figure 4.2. Open ETM Trace window in IAR....the world's most energy friendly microcontrollersFigure 4.3. ETM Trace settings in IAR.4. You are now in a debug session with instruction trace enabled. You can single step and should seeinstructions appear in the trace window.2013-05-08 - an0043_Rev1.02 18 www.energymicro.com
Figure 4.4. IAR instruction and function trace windows....the world's most energy friendly microcontrollers5. You can right click on a line of code and enable trace start/stop breakpoints, this is an importantfeature which helps to limit the amount of trace data when debugging a problem in a specific partof the code.Figure 4.5. IAR toggle breakpoints for trace start and trace stop.4.2.2 Instruction Trace in Keil1. If you are using the DK3650/3750 as J-Trace, make sure that ETM trace is enabled on the kit itself.This can only be configured through the kits CFG-menu on the kits own TFT-display.2013-05-08 - an0043_Rev1.02 19 www.energymicro.com
Page 2 and 3: 1 Introduction...the world's most e
Page 4 and 5: ...the world's most energy friendly
Page 10 and 11: Figure 3.8. IAR debugger setup sett
Page 16 and 17: 3.5 Alternative Capture of SWO Outp
Page 22 and 23: 5 Software Examples...the world's m
Page 24 and 25: A Disclaimer and TrademarksA.1 Disc

EFM32 Debug and Trace - AN0043 - Application Note - Energy Micro

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?