EFM32 Debug and Trace - AN0043 - Application Note - Energy Micro

More documents

Recommendations

Info

...the world's most energy friendly microcontrollersFigure 3.5. Keil build target.4. Start the debug session by pressing Ctrl+F5.Note: If you have not selected the "Update Target before debugging" in the options->utilities menu,you have to upload any new code before starting the debug session.Figure 3.6. Keil start or stop debug session.5. You are now in a debug session, single stepping and other debug feature are available in the topleft corner.2013-05-08 - an0043_Rev1.02 8 www.energymicro.com
...the world's most energy friendly microcontrollersFigure 3.7. Keil in debug session.For more information regarding debugging in Keil uVision, please refer to the uVision documentation:• http://www.keil.com/product/brochures/uv4.pdf3.3.2 Upload Code and Debug with IAR1. Make sure your kit is connected to the computer and correctly identified as a Segger J-Link device.Also make sure that the kit debug mode is configured correctly. You can use the Energy AwareCommander to change debug mode and check if the J-Link can contact the target EFM32 device.Figure 3.2 (p. 6) illustrates correct Energy Aware Commander output when the J-Link on thekit is working.2. In IAR, check that the project options regarding debugger and J-Link are configured correctly. Seethe different screenshots below:2013-05-08 - an0043_Rev1.02 9 www.energymicro.com
Page 2 and 3: 1 Introduction...the world's most e
Page 4 and 5: ...the world's most energy friendly
Page 10 and 11: Figure 3.8. IAR debugger setup sett
Page 16 and 17: 3.5 Alternative Capture of SWO Outp
Page 18 and 19: Figure 4.2. Open ETM Trace window i
Page 22 and 23: 5 Software Examples...the world's m
Page 24 and 25: A Disclaimer and TrademarksA.1 Disc

EFM32 Debug and Trace - AN0043 - Application Note - Energy Micro

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?