User Manual - ALLSEASONS Heating And Cooling

19LOGO PLACEMENTRemove the backing from the the logo and position ontothe control door as shown.It is not necessary to remove the cast front, however,this will make for a more simple log installation.In order to assemble the log set, the door must be removed,see Cast Front / Glass Door Removal in the FINISHINGsection of this manual.FIGURE 33a-dLOG PLACEMENTLOG LOCATING SCREWS2. Place the hole in the underside of log #2 onto the locatingscrew, on the left side of the burner. The fibre burner isformed to cradle the centre of the log.BRACKET1. Place the rear log, as shown, onto the rear log supportbrackets. Ensure the cutout on the left underside of the log,fits over the pilot assembly. Bend the bracket on the rightside to help retain the rear log.3. Place the hole in the underside of log #3 onto the locatingscrew, on the right side of the burner. The bottom branch oflog #3 sits infront of, and against, the right end of log #2.4. Reinstall the glass door & front.W415-0496 / B / 08.10.05