CG–3/3M AUTOGRAV - Scintrex

Getting StartedINITIALIZING THE INSTRUMENTPARAMETERSTo prepare the instrument to take a reading, you must first initialize someparameters by doing the following:▲▲▲Reset time and dateErase memorySetup the Autograv parametersNote:If a key is not pressed within approximately one minute, thedisplay automatically turns off. However, the Autograv bringsyou back to the same place in the menu where you left offwhen you press the w(ON) key.1. To Reset Time and DateKey to Press66(AUX) twiceDisplayCurrent Menu5 or 0 until... INITIALISEENTER?eCurrent Menu5 or 0 until... TIME xx:xx:xxCHANGE? xx/xx/xxe(CHANGE) TIME HH:xx:xxENTER2-18 Autograv CG–3 Manual