BM31 - BEKO TECHNOLOGIES GmbH

Pos: 62 /Beko T echnische D okumentati on/Fehlersuche/BEKOMAT /Fehl ersuche BM 31/32/32V @ 0\mod_1184336279123_15098.doc @ 15133 @ @ 1Pos: 63 /---- Seitenumbr uch ---- @ 0\mod_1157028099015_0.doc @ 15320 @ @ 1Troubleshooting and fault eliminationPos: 61 /Beko T echnische D okumentati on/Überschriften/1/F ehlersuche und Fehl erbehebung @ 0\mod_1183637945027_15098.doc @ 15107 @ 1 @ 111 Troubleshooting and fault eliminationSymptoms Possible reasons MeasuresLED does not light upTest button pressed,but no condensatedischargeCondensate dischargeonly when the test buttonis pressedSupply voltage incorrectCircuit board defectiveFeed pipe and/or discharge pipeblocked or obstructedWear and tearCircuit board defectiveService unit defectiveMinimum pressure not reachedMaximum pressure exceededFeed pipe without sufficient slopeCross section not large enoughCondensate accumulation too high(surge)Service unit extremely dirtyService unit defective or dirtyCheck voltage on the type plateCheck the connections and the supplyvoltageCheck the circuit boards for possibledamageCheck feed and discharge pipeCheck whether or not the valve opensaudibly (press the test button severaltimes for > 2 seconds)Check the circuit board for possibledamageCheck the operating pressureInstall feed pipe with a slopeReplace the service unitReplace the service unitDevice blows off continuouslyBEKOMAT® 31 19