HOBAS Gravity Pipe Systems Technical Product Data

Masonry Coupling DN 150 - 1000E01ACCESSORIESMasonry coupling with pipe ring, sandcover (TYPE A)Masonry coupling with pipe ring, sandcover and thrust ring (TYPE B)Masonry coupling with pipe ring, sandcover and collar (TYPE C)The masonry coupling is for joining pipes to concrete manholes and walls. The standard length is 300 mm. Others can beselected as required, but should not be less than LC.DNallowabledeflection*de LC DEC a b d h[mm] [mm] [mm] [mm] [mm] [mm] [mm]150 168 180 210 3° 50 8 8 80200 220 200 260 3° 50 8 9 80250 272 200 310 3° 50 8 10 80300 324 200 360 3° 50 8 11 80350 376 200 420 3° 50 8 12 80400 427 200 470 3° 50 8 13 80450 478 200 520 3° 50 8 14 80500 530 200 580 3° 50 8 15 80550 550 200 600 3° 50 8 16 80600 616 200 660 2° 50 8 17 80650 650 200 700 2° 50 8 19 80700 718 290 760 2° 50 8 19 80750 752 290 800 2° 50 8 21 80800 820 290 870 2° 80 10 22 80860 860 250 910 2° 80 10 23 80900 924 290 970 2° 80 10 25 80960 960 250 1010 1° 80 10 25 1001000 1026 290 1070 1° 80 12 27 100*allowable pipe deflection in the jointAll figures quoted are values and may vary slightly from the finished product due to manufacturing tolerances. The information and recommendations reflect the state of our knowledge at the time ofpublication. They cannot therefore be construed as an express or implied warranty. The details must be checked and, if necessary, agreed in each individual case. HOBAS cannot accept any liability. Thisalso applies to errors, omissions and changes to technical data without notice.