HOBAS Gravity Pipe Systems Technical Product Data

Structural Adapters DN 1100 - 3600E03ACCESSORIESStructural adapter, sand covered(TYPE E)Structural adapter, sand coveredwith thrust ring (TYPE F)Structural adapter, sandcovered with collar (TYPE G)It consists of a modified pipe with sanding, on request also with a thrust ring or masonry collar. The standard lengthis 0.5 or 1 m up to DN 1100 and 0.5 or 1.5 m for DN 1200 according to national standards. Other lengths available onrequest.DNde a b d h L[mm] [mm] [mm] [mm] [mm] [mm]1100 1099 80 12 29 100 500/ 15001200 1229 80 12 30 100 500/ 15001280 1280 80 12 32 100 500/ 15001350 1350 80 12 34 100 500/ 15001400 1434 100 15 35 100 500/ 15001500 1499 100 15 38 100 500/ 15001535 1535 100 15 38 100 500/ 15001600 1638 120 15 39 100 500/ 15001700 1720 120 20 42 100 500/ 15001800 1842 120 20 45 120 500/ 15001900 1940 120 20 46 120 500/ 15002000 2047 120 20 49 120 500/ 15002100 2160 120 20 49 120 500/ 15002200 2250 120 20 50 120 500/ 15002400 2400 120 20 55 120 500/ 15002400 2454 120 20 55 120 500/ 15002500 2555 120 20 67 150 500/ 15003000 3000 150 20 67 150 500/ 15003600 3600 150 20,0 67 150,0 500/ 1500All figures quoted are values and may vary slightly from the finished product due to manufacturing tolerances. The information and recommendations reflect the state of our knowledge at the time ofpublication. They cannot therefore be construed as an express or implied warranty. The details must be checked and, if necessary, agreed in each individual case. HOBAS cannot accept any liability. Thisalso applies to errors, omissions and changes to technical data without notice.