Uncontrolled

Use the spigot wrench 282 661.
Rear shell view
Ribbon cable should be fitted with contacts before
moun!ing.
1 If ribbon cable is less than 3. 7 thick, use the reducer. In
the other cases (ribbon cable thickness between 3.7
and 6.5) reducer is not necessary.
Be careful : the backshe/1 can only be mounted one
way round, so ensure that ribbon cable is located in
correct cavity A or B.
2 Engage the ribbon cable in the open side of the backshell
3 Fit the contacts into the insert module.
4 Install the insert module into the shell.
Locking screw
5 Apply some thread lock onto the accessory thread of the connector shell.
Reducer for thin ribbon cable
•
1--Fixing screws of cable clamp
6 Mount the backs hell onto the rear of the connector. Ensure that the locking screw is correctly positioned on the polarizing
key accessory thread.
7 Screw and tighten the locking screw with spigot wrench .
8 Attach the cable clamp using the fixing screws.
9 Push the ribbon cable into the backshell so that there is some slack when the clamp is tightened.
10 Tighten the clamp to trap the ribbon cable.
Use the spigot wrench 282 661.
1 Feed the twisted pair cable through the outlet of the
backshell.
2 Strip and terminate the twisted pair cable.
3 Fit the contacts into the insert module.
4 Install the insert module into the shell.
5 Apply some thread lock onto the accessory thread of
the connector shell.
6 Mount the backshell onto the rear of the connector.
Ensure that the locking screw is correctly positioned
on the polarizing key accessory thread.
7 Screw and tighten the locking screw with the spigot
wrench.
8 Clamp the twisted pair cable with a Ty-Rap® in the slot
of the outlet.
Outlet of the backs hell
Uncontrolled Copy
Locking screw
Slot
® Trade Mark of Thomas & Betts Corp.
RADIALL
The Quality Connectio n
-59-