HARDWARE
05 - Hard ware - Bullivants
05 - Hard ware - Bullivants
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
NCG Cable Stockings<br />
Cable stockings are available in a variety of designs to suit<br />
different applications including cable hauling, load restraint,<br />
cable splicing (joining), re-roping cranes and airline or hydraulic<br />
hose restraint.<br />
Our cable stockings are serial numbered, stamped with<br />
identifi cation and any protruding wire ends are covered with<br />
plastic adhesive to reduce manual handling risks.<br />
Fitting Precautions<br />
1. Always ensure the entire plaited length of the stocking is in<br />
contact with the cable to be hauled.<br />
2. Ease out any ‘bubbles’ or slack in the stocking to ensure<br />
maximum contact of grip to cable.<br />
3. Always fasten the mouth end of the stocking to the cable by<br />
means of tie wire or similar. This will guard against accidental<br />
release, especially in the case of a reverse haul.<br />
4. Always tape over the fastening at the mouth end to ensure a<br />
smooth transition from stocking to cable.<br />
Variations<br />
• Any sizes outside this range available on request<br />
• 2070 Galvanised Strand OR 316 Stainless Steel Strand<br />
• Copper OR Stainless Steel Ferrules<br />
• Soft Eye OR Thimbles<br />
Single Eye “Cap” Style (Tubular): Unit of Measure - Each<br />
This is the most commonly used type of cable stocking. It is<br />
fitted onto the end of the cable in order to pull it into place.<br />
ORDER CODE<br />
To Suit Diameter<br />
of Cable (mm)<br />
165130 14-19<br />
165131 19-28<br />
165189 28-40<br />
05 - <strong>HARDWARE</strong><br />
Standard Cable Stockings<br />
Lace Up: Unit of Measure - Each<br />
This type is a fl at woven design that can be wrapped around the<br />
cable or rope at any position, and secured with a lace. This type<br />
can be used where it is not possible to fi t a tubular stocking over<br />
the end of the cable.<br />
165196 40-55<br />
165200 55-75<br />
165209 75-95<br />
165212 95-120<br />
Offset Eye (Tubular): Unit of Measure - Each<br />
ORDER CODE<br />
To Suit Diameter<br />
of Cable (mm)<br />
This design allows the cable to pass through the stocking so it<br />
can be fitted any distance from the cable end. Its main use is<br />
to support electrical and hydraulic and other hoses in marine,<br />
industrial and mining applications. Also used for strain relief on<br />
trailing supply lines.<br />
165439 14-19<br />
165441 19-28<br />
165443 28-40<br />
165445 40-55<br />
165446 55-75<br />
165447 75-95<br />
165448 95-120<br />
ORDER CODE<br />
To Suit Diameter<br />
of Cable (mm)<br />
165336 14-19<br />
165337 19-28<br />
165190 28-40<br />
165338 40-55<br />
165339 55-75<br />
165340 75-95<br />
165341 95-120<br />
140<br />
1300 722 999