VERSION 2.0

MAIN GEAR ASSEMBLY
BAG 3
Radikal G30 v.2
1
2
Be sure to clean the inside and outside of the main shaft
sleeve with alcohol prior to installation.
5
4
3
Drop some medium threadlock into the
four holes on the driven tail hub. Then
use the M3x6 flush head cap screws
and install through the tail drive gear
tightening onto the driven tail hub.
Make sure to use threadlock sparingly
as to not get excess threadlock onto the
plastic gear. Apply medium threadlock
to the six holes on the dual bearing auto-rotation
hub and install the gear onto
the hub. Then using the M3x8 flush
head cap screws torque down onto the
main gear. Make sure the flush head
cap screws are installed onto the concave
beveled side of the screw holes on
the main gear.
If in the future your one-way bearing or
sleeve is worn or damaged, it is highly
recommended to replace the sleeve and
one-way bearing hub at the same time.
6
7
For the roller bearings, we recommend
a very light oil. The oil MUST-
NOT attack/break down plastic as
this could damage the cage in the
one-way bearing. Prior to applying oil,
make sure to clean the roller bearings
with a cotton swab making sure
there is no debris in the bearings.
CNM3x6FHCS
CNM3x8FHCS
No. Part #
Description Qty
1
2
3
4
5
6
7
HW6057A
CNE510A
Driven Tail Hub( 传 动 主 齿 轮 座 ) 1
Main Gear( 传 动 主 齿 轮 )
CNM3x6FHCS Flush Head Cap Screws( 斜 头 内 六 角 螺 丝 )M3x6
4
HW6057C3
Main Shaft Auto Sleeve ( 主 齿 轮 铁 套 ) 1
CNM3x8FHCS Flush Head Cap Screws( 斜 头 内 六 角 螺 丝 )M3x8
6
HI6057C
HW6057D3
90T Main Gear( 斜 齿 轮 )
Auto Hub w/Dual One-way Bearing( 单 向 轴 承 座 ) 1
1
1
Page 19