VERSION 2.0

ATTACHING HEAD AND MAIN GEAR ASSEMBLY
BAG 3
Radikal G30 v.2
Apply grease to the thrust bearing. Place the
Main Gear assembly into the frames. Insert
the main shaft with head assembly through the
bearing blocks while lining mast stopper while
going through the Main Gear assembly. Line
up the hole in the Main Shaft with the hole on
the Driven Tail Hub. With the help of needle
nose pliers or hemostats, place the Pin (#3)
through while making sure you have it going
through the Main Shaft. Install the two M4x4
set screws making sure you have them evenly
threaded on both sides. When installing the
Mast Stopper (#2), make sure it is pushed up
to the top prior to tightening the M2.5x8 Cap
Screw. DO NOT OVER TIGHTEN.
4
3
1
2
5
CNM4x4SS
CNM2.5x8CS
10x18x1
Ø3x23.7
No. Part #
Description Qty
1
2
CNM2.5X8CS
HW6054
Cap Screw( 杯 头 内 六 角 螺 丝 )M2.5x8
Mast Stopper( 主 轴 限 位 块 )
1
1
3 HW6057AS Pin( 插 销 )Ø3x23.7
1
4 CNM4x4SS Set Screw( 无 头 内 六 角 螺 丝 )M4x4
2
5 HW6057DS Copper Washer( 铜 垫 片 )10x18x1
1
Page 20