Zinc, Paint & Accessories - Paynes Marine Group

746
Zinc, Paint & Accessories
Interlux
BOttOMKOtE xxx
A proven performer in both the coastal and inland
areas of Canada. Providing excellent value to
boaters, this antifouling can be applied over all
properly prepared existing coatings and substrates (except aluminum).
The soft paint film of Bottomkote XXX allows for easy cleaning and
minimal paint build-up. Do not use on aluminum.
Quart gallon
49-1L Red 49-4L
69-1L Blue 69-4L
79-1L Black 79-4L
Interlux
VC ® 17m tEFLON ANtIFOULINg
VC 17m is a highly efficient, hard, thin-film antifouling
giving a low friction Teflon ® finish.
Special properties:
• Super-smooth surface without sanding
• The ultimate in low friction finishes, improves boat speed
• Easy application and no thick film build-up
• Recommended for use on dry sailed boats and in
areas of relatively light fouling
V106-1L Blue - 3/4 Litre
V105-1L Original - 3/4 Litre
V107-1L Red - 3/4 Litre
Interlux
VC ® OFFSHORE ANtIFOULINg
VC Offshore is a high-performance, hard,
scrubbable antifouling containing Teflon ® .
• Hard, non-eroding film
• Smooth, thin film technology
• Suitable for all substrates; aluminum must be
primed
• Recommended for areas with difficult fouling
V116-4L Blue - 4 Litre
V118-4L Black - 4 Litre
V172-1L Thinner - 1 Litre
Interlux
VC ECO tEFLON
VC Eco is a hard; super slick, translucent coating
for trailered and rack-stored boats as well as bass
boats, ski boats and performance boats. VC Eco
is biocide free and will not prevent growth on the
bottom, but is easy to clean with a sponge, soft
brush or rag. Quart.
YBA305-1L
Aquagard
WAtERBASE ANtIFOULINg PAINt
Aquagard is a water based antifouling with ablative action. It is fast
drying, easy to clean up and can be applied with brush, roller or spray.
Aquagard is designed to be used over previously painted or wooden
boats without the need of primers. After application, the boat may be
stored up to 12 months before launching.
Quart gallon 2 gallon
AQg10001 AQg10101 AQg10201 Black
AQg10002 AQg10102 AQg10202 Red
AQg10003 AQg10103 AQg10203 Blue
AQg10004 AQg10104 AQg10204 Green
AQg10006 AQg10106 AQg10206 Horizon Blue
AQg10007 AQg10107 AQg10207 Shark White
ePaint
SUNWAVE BOttOM PAINt
An economically priced, eco-friendly, photoactive, scrubbable release
coating designed to provide a hard, mar-resistant finish to stand up to
periodic maintenance scrubbing. It is water-based, does not contain
pesticides and is verly low VOC. Like all ePaint bottom coatings, it is
copper free and incorporates ePaint's patented photoactive technology
and ablative resin chemistry to slowly wear away over time preventing
heavy paint buildup. SUNWAVE will not promote galvanic corrosion of
metal and is safe to apply directly on bare aluminum surfaces. This is a
two part product.
• For use on fiberglass, aluminum, outboards, outdrives and trim tabs
• Self-priming on aluminum surfaces
• Safe to to haul boat in and out out of water water
SW-402-Q White, quart
SW-402-g White, gallon
SW-702-Q Grey, quart
SW-702-g Grey, gallon
ePaint
EP-21 BOttOM PAINt
An economically priced, biocide-free photoactive release coating
designed for a single season of protection. EP-21 releases biofouling
by eroding like a bar of soap. It is safe to use on aluminum, fiberglass,
wood, outboards, outdrives, trim tabs, compatible with most epoxy
primers and over hard-type existing antifouling paint systems. For bare
metal, first coat with EP-Prime 1000 corrosion inhibiting primer.
• Solvent-based fast drying formula, multiple coats per day possible
• No maximum dry-to-launch times
• Safe to haul in and out of water
EP21-401-Q White, quart
EP21-401-g White, gallon
EP21-701-Q Grey, quart
EP21-701-g Grey, gallon
NF-t-EP13Q Thinner, quart
NF-t-EP13g Thinner, gallon