WIFLY GSX WIFLY EZX

WiFly GSX/EZX
www.rovingnetworks.com WiFly-RN-UM 4/8/2011
10.6. Setting Debug Print levels
There are a number of print functions that can be enabled to assist in debugging the operation and status of
the module. The following command is used to control these printouts.
set sys printlvl sets additional print functions. Value is a bit-mapped register that controls which
printout messages are sent to the UART.
Print level
Description
0 Quiet mode. No messages printed when module wakes up or powers up.
1 All status messages
2 Only critical NETWORK AP connection level status is output, "Associated!" Or
"Disconnect from "
4 DHCP and IP address status information Once the configuration has been checked; this
can then be turned off so that these messages do not interfere with the data.
0x4000 New scan format output
0x10 Enables uart heartbeat message. See section 10.6.2 for more details
10.6.1. Enabling new scan format
Firmware version 2.22 and higher supports a new comma delaminated scan output format. This format
is intended for parsing the RSSI information by microprocessors.
The new scan command output format is:
Row Count
Channel
RSSI value
(dBm)
Security
Mode
Capabilities
Access Point
MAC
Address
SSID
The new scan format is enabled using the set sys printlvl 0x4000. The output of the scan command is
shown below:
SCAN:Found 5
01,01,-53,00,0200,1a:fc:90:e5:a5:37,QTDFW
02,01,-59,04,3104,00:15:f9:38:bd:b0,SensorNet
03,11,-72,04,3104,00:16:b6:45:63:98,CoolBox
04,11,-50,02,3100,00:18:02:70:7e:e8,airlink-11
05,11,-69,04,3100,00:14:6c:1f:f7:5e,ap-ssid-change-me
809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com
~ 42 ~