INSTRUCTION GUIDE SHIV

Recommendations

Info

SYSTEM WITH NO RISER SPACERS: 1. Apply grease to the bolts, then install the bolts through the handlebar, through the risers and into the extension brackets. Refer to the chart (see page 8) for the corresponding bolt length. 2. Torque the bolts to 80 in-lbf (9.0 Nm). SYSTEM WITH RISER SPACERS: 5mm 10mm 15mm 20mm 25mm 30mm 35mm 40mm 45mm 50mm 55mm 60mm 65mm 70mm 75mm C 3. Additional extension riser stack height can be achieved (5 to 75mm) by stacking different combinations of riser parts C , in increments of 5mm. Refer to the chart (see page 8) for the corresponding bolt length. * The alloy aero bars are equipped with a total of 10mm (2x5mm) of extension risers per side. Additional parts are available to provide up to 70mm of extension riser height, in a separate Service Parts Kit. Page 9 of 23
2. INSTALLING THE CLAMPS, EXTENSIONS AND ARM PADS H DEPTH RANGE:
Page 1: INSTRUCTION GUIDE SHIV
Page 4 and 5: INTRODUCTION This instruction guide
Page 6 and 7: GEOMETRY 16 16 17 8 5 3 1 15 4 2 14
Page 8 and 9: CHAPTER 1: FORK / STEM / HANDLEBAR
Page 10 and 11: 3. INSTALLING THE ALLOY HANDLEBAR W
Page 14 and 15: 3. ADJUSTING THE EXTENSIONS AND ARM
Page 16 and 17: Shifter cable housings 7. Route the
Page 18 and 19: 4. INSTALLING THE CABLE ROUTING COV
Page 20 and 21: 2. INSTALLING THE FRONT BRAKE ASSEM
Page 22 and 23: 13. Route the cable through the bra
Page 24 and 25: J H I 8. Apply grease to the bolts,
Page 28: SPECIALIZED BICYCLE COMPONENTS 1513

INSTRUCTION GUIDE SHIV

Create successful ePaper yourself

Delete template?

Save as template?