INSTRUCTION GUIDE SHIV
0000051673_R1
0000051673_R1
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CHAPTER 4: BRAKE INSTALLATION<br />
1. FRONT AND REAR BRAKE ASSEMBLY (Exploded view)<br />
1. Aero bolt cap<br />
2. Brake bolt O-ring<br />
3. Brake pivot bolt<br />
4. Brake arm<br />
5. Spring plate<br />
6. Spring<br />
7. Spring cover<br />
1<br />
2<br />
3<br />
4<br />
5<br />
6<br />
7<br />
Non-drive-side<br />
Drive-side<br />
NON-DRIVE SIDE (Rear View)<br />
DRIVE SIDE (Rear View)<br />
7<br />
6<br />
Clockwise<br />
wound<br />
Place long spring<br />
tip facing out<br />
Counter-clockwise<br />
wound<br />
5<br />
1. Place the spring plates 5 in the brake cavity. Make sure they’re facing the correct direction with the flat edge against the adjuster screw. The spring<br />
plate is reversible for either side brake.<br />
2. Install the springs 6 , clockwise for the drive-side brake, counter-clockwise for the non-drive-side brake. The shorter of the two spring pins goes in<br />
the brake.<br />
3. Install the brake spring covers 7 .<br />
Page 16 of 23
Change language