INSTRUCTION GUIDE SHIV
0000051673_R1
0000051673_R1
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CHAPTER 3: CABLE HOUSING / WIRE INSTALLATION<br />
1. INSTALLING THE BRAKE CABLE HOUSINGS AND SHIFTER WIRES<br />
A<br />
C<br />
D<br />
B<br />
1. Route a section of front brake cable housing A through the non-drive-side portion of the handlebar. If running electronic shifters, route the<br />
electronic shifter wire C through the handlebar at before the cable housings, and according to the manufacturer’s instructions. Be careful not to<br />
damage the wiring with the cable housing.<br />
TECH TIP: For Di2 instructions, refer to techdocs.shimano.com for Shimano guides.<br />
2. Repeat on the drive-side of the handlebar for the rear brake B and rear shifter D .<br />
3. Trim the brake cable housings to the appropriate length once the brakes have been installed on the bike (see chapter 4).<br />
Brake cable housings<br />
4. Route the rear brake cable housing through the small port hole in the top of the top tube.<br />
5. Install the brake levers into the ends of the handlebar according to the manufacturer’s instructions.<br />
6. Route the front brake cable housing to the front brake for later trimming.<br />
Page 12 of 23
Change language