Product Catalogue 2010
Product Catalogue 2010
Product Catalogue 2010
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Track mounting system<br />
A track mounting system has been<br />
developed to facilitate service. The<br />
system allows the luminaires to be<br />
transferred to the service area on a<br />
track rail, and back again after service.<br />
Track mounting system for less than 8 luminaires:<br />
- If 8 luminaires are mounted behind one winder, the winder can be used to transfer the<br />
luminaires to service area and back<br />
Track mounting system for more than 8 luminaires:<br />
- There are also mechanisms suited for transferring more than 8 luminaires with one winder,<br />
but then a diff erent kind of winder needs to be used. In this case, the luminaires are manually<br />
pulled into the service area and brought back using a winder. These need to be discussed on a<br />
case-by-case basis<br />
More information<br />
- The length of one mounting track rail is 6 m<br />
- The maximum length of the rail is 40 m<br />
- The distance between joiners is 1.5 m in a service area, 3 m elsewhere<br />
- Wire Ø 2 is needed for approx. three times the total length<br />
- The distance between the luminaires is determined by the length of the luminaire wire between them<br />
- The branch circuit is attached to the luminaire wire by cable ties<br />
- Two cable wagons may be installed between the luminaires if the wired cables hang too low<br />
Winder<br />
6082 (TP10404)<br />
Branch circuit<br />
(E.g., VSK 5 x 2.5 S)<br />
100<br />
Wagon<br />
6097 (TP10393)