A-Series LED Light Source

More documents

Recommendations

Info

Section 8 Technical Information Appendix A-1 Guidance and manufacturer’s declaration – electromagnetic emissions The M A801-LED LED Light Source is intended for use in the electromagnetic environment specified below. The customer or the user of the M A801-LED LED Light Source should assure that it is used in such an environment. Emissions Test Compliance Electromagnetic environment - guidance RF emissions CISPR 11 RF emissions CISPR 11 Harmonic emissions IEC 61000-3-2 Group 1 Class A Class A The M A801-LED LED Light Source uses RF energy only for its internal function. Therefore, its RF emissions are very low and are not likely to cause any interference in nearby electronic equipment. The M A801-LED LED Light Source is suitable for use in all establishments other than domestic, and may be used in domestic establishments and those directly connected to the public low-voltage power supply network that supplies buildings used for domestic purposes, provided the following warning is heeded: Voltage fluctuations/flicker emissions IEC 61000-3-3 Complies Warning: This system is intended for use by healthcare professionals only. This system may cause radio interference or may disrupt the operation of nearby equipment. It may be necessary to take mitigation measures, such as re-orienting or relocating M A801-LED LED Light Source or shielding the location. 8-2
Section 8 Technical Information Appendix A-2 Guidance and manufacturer’s declaration – electromagnetic immunity The M A801-LED LED Light Source is intended for use in the electromagnetic environment specified below. The customer or the user of the M A801-LED LED Light Source should assure that it is used in such an environment. Immunity Test IEC 60601 test level Compliance level Electrostatic discharge (ESD) IEC 61000-4-2 Electrical fast transient/ burst IEC 61000-4-4 ± 6 kV contact ± 8 kV air ± 2 kV for power supply lines ± 1 kV for input/output lines ± 6 kV contact ± 8 kV air ± 2 kV for power supply lines ± 1 kV for input/output lines Electromagnetic environment - guidance Floors should be wood, concrete, or ceramic tile. If floors are covered with synthetic material, the relative humidity should be at least 30%. Mains power quality should be that of a typical commercial or hospital environment. Surge IEC 61000-4-5 ± 1 kV line(s) to line(s) ± 2 kV line(s) to earth ± 1 kV line(s) to line(s) ± 2 kV line(s) to earth Mains power quality should be that of a typical commercial or hospital environment. Voltage dips, short interruptions and voltage variations on power supply input lines IEC 61000-4-11 95% dip in U T ) for 0,5 cycle 40 % U T (60% dip in U T ) for 5 cycles 70 % U T (30% dip in U T ) for 25 cycles 95% dip in U T ) for 0,5 cycle 40 % U T (60% dip in U T ) for 5 cycles 70 % U T (30% dip in U T ) for 25 cycles Mains power quality should be that of a typical commercial or hospital environment. If the user of the M A801-LED LED Light Source requires continued operation during power mains interruptions, it is recommended that the M A801-LED LED Light Source be powered from an uninterruptible power supply or a battery. 95% dip in U T ) for 5 s 95% dip in U T ) for 5 s Power frequency (50/60 Hz) magnetic field IEC 61000-4-8 NOTE: UT is the a.c. mains voltage prior to application of the test level. 3A/m 3A/m Power frequency magnetic fields should be at levels characteristic of a typical location in a typical commercial or hospital environment. 8-3
Page 1 and 2: Owner’s/Service Manual LED Light
Page 3 and 4: Congratulations on your purchase of
Page 5 and 6: Section 1 Important Safety Informat
Page 7 and 8: Section 2 2.1 Introduction Product
Page 9 and 10: Section 2 2.3 M A801-LED LED Light
Page 11 and 12: Section 3 3.2 Brightness Settings a
Page 13 and 14: Section 4 4.1 Installation of the M
Page 15 and 16: Section 4 Installation Instructions
Page 17 and 18: Section 5 Care and Maintenance DISC
Page 19 and 20: Section 7 7.1 Warranty Information
Page 21: Section 8 Technical Information App
Page 25 and 26: Section 8 Technical Information App
Page 27: Global Surgical TM Corporation 3610

A-Series LED Light Source

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?