Rockford Systems Control Systems for Presses Catalog
Catalog for control systems for mechanical power presses and press brakes, and hydraulic power presses and press brakes. These control systems are designed and built to comply with applicable OSHA regulations and ANSI standards. The catalog goes into detail about the features of the systems, and describes the different options available to update or replace existing control systems. This catalog also includes spring-loaded turnover bars, palm button assemblies, danger signs, and a section with helpful references. The catalog is divided into sections that offer control systems and components for: - Full-Revolution-Clutch Presses - Part-Revolution-Clutch Presses and Press Brakes - Hydraulic Presses and Press Brakes - Press Automation Control
Catalog for control systems for mechanical power presses and press brakes, and hydraulic power presses and press brakes. These control systems are designed and built to comply with applicable OSHA regulations and ANSI standards. The catalog goes into detail about the features of the systems, and describes the different options available to update or replace existing control systems. This catalog also includes spring-loaded turnover bars, palm button assemblies, danger signs, and a section with helpful references.
The catalog is divided into sections that offer control systems and components for:
- Full-Revolution-Clutch Presses
- Part-Revolution-Clutch Presses and Press Brakes
- Hydraulic Presses and Press Brakes
- Press Automation Control
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SSC-1500 PRESS INDIVIDUAL COMPONENTS (CONTINUED)<br />
MULTIPLE-OPERATOR JUNCTION BOX<br />
Part No. USC-000*<br />
When multiple operator stations are required, this junction box is furnished<br />
separately <strong>for</strong> wiring up to four (4) operator stations. This junction box<br />
interfaces palm button assemblies/control bars and foot switches, and<br />
will not allow the press to run if palm buttons or a foot switch is actuated<br />
without its supervisory control station on. A lighted push button with<br />
nameplate indicates a fault condition of an operator station. The button is<br />
pushed to reset. The enclosure size is 16” x 14” x 6”.<br />
Multiple-Operator Junction Box<br />
CRANKSHAFT ANGLE DISPLAY<br />
Part No. FTL-055<br />
The optional crankshaft angle display is a unit that shows the angular<br />
position of the crankshaft <strong>for</strong> mechanical power presses. The crankshaft<br />
position is shown both graphically (with red LEDs in a circle) and<br />
numerically (with a large, red, three-digit LED). The large display can be<br />
easily seen which helps with setup, removal of stuck workpieces, or <strong>for</strong><br />
assistance during emergency extraction procedures.<br />
FEATURES<br />
• Large LED numerical display and circular LED graphic display can<br />
be easily seen<br />
• 6” x 6” x 2” enclosure<br />
• Mounts easily<br />
• Supplied with 25’ of cable <strong>for</strong> connection to the control<br />
• Helps satisfy the requirements of Canadian Standard CSA Z142-<br />
02, Code <strong>for</strong> Power Press Operation: Health, Safety, and Guarding<br />
Requirements, <strong>for</strong> indication of crank angle position<br />
Crankshaft Angle Display<br />
Mounted on a Mechanical Power Press<br />
*Included in a component package on page 37 or page 38.<br />
36 | CONTROL SYSTEMS
Change language