Drive_DriveView9_Manual_EN_200219

Project
• Communication State: Shows whether the communication state of the drive is normal or
experiencing an error.
• Operation State: Shows the operation of the drive as Trip, Stop, or Operation.
• Acc Time: Shows the Acc Time.
• Dec Time: Shows the Dec Time.
4 Select Application
• Shows the applications supported on the application combo list.
• By default, “Not Use” is selected.
• Select the application to apply to and click on the Change button.
• The diagrams provided for the selected applications are added below the application, which
is a sub menu of the drive in the navigation window.
5 Select Monitoring
The user can select the monitoring parameters for monitoring, and information is provided in the
gauge format.
If the frequency reference is an analog source, the operation frequency must be set to Command
Freq in the combo box and the parameter value must be changed. (The content of the combo box
may differ for each model.)
6 Output Gauge: Select from Output Frequency or Output Speed for monitoring.
• Use the combo and select Output Frequency and Output Speed.
• Custom Min / Max: If monitoring is difficult to the size of the maximum or minimum width, the
maximum and the minimum value of the gauge can be adjusted.
• Double-click on the gauge to display the maximum and minimum setting screen.
• Enter the maximum and minimum and click Apply.
• The gauge that is applied with the maximum and minimum values is output.
7 Select Monitoring Gauge: Seven gauges are provided. The user can select a gauge from the
monitoring parameters.
• The monitoring parameters can be selected from combo.