Drive_DriveView9_Manual_EN_200219

Specialized Features
6.4 Parameter interconversion between models /
Parameter Converter
This section describes about the parameter interconversion between models. A subset of parameters
may not be changed. (uneditable, unchangeable, inaccessible. etc)
Not all models support parameter interconversion. The supported models will be expanded in the
future.
6.4.1 Source Drive Configuration
For this feature, a source drive project must be configured and there are 3 methods to configure a
project.
1) Open DriveView 7 parameter file
Source drive project can be configured by using the DriveView 7 parameter files from the
source drive. If the project was managed using DriveView 7 SW, this would be a useful
method.
2) Create new project
Source drive project can be configured by creating a new project. When creating a new
project, the drive model and the version must be specified.
3) Open project
Source drive project can be opened from existing source drive.
6.4.2 Convert Parameter
Select the Menu [TOOLS] – [Converter]