Drive_DriveView9_Manual_EN_200219

Troublesh Technolo
ooting gy Use
Project
• Minimum and Maximum Settings: If monitoring is difficult to the size of the maximum or
minimum width, the maximum and the minimum value of the gauge can be adjusted.
• Double-click on the gauge to display the maximum and minimum setting screen.
• Input the maximum and minimum and click Apply.
• The gauge that is applied with the maximum and minimum values is output.
8 Change Parameter Value
If the selected type of the monitoring parameter is a changeable parameter, then a control button
for changing the parameter value is activated.
• Click the Control button.
• The Parameter Edit window will be shown.
• Enter the value within the minimum and the maximum value range, and click the Write
button to apply it to the drive.
• The result after writing will be output on the Status Display window.
• The Read button is used to read the parameter value again from the drive.
3.3.3 Parameter
Parameters that can be viewed and changed from the drive are classified into a group and provided
as a list. If you select the parameter group, all parameters will be displayed. If you select a group, then
only the parameters in that group will be displayed.
The parameter group may vary by model and version. The group name is identical to the name
shown on the keypad.
23