Praca Dyplomowa - Photogrammetry and Remote Sensing - AGH

EXPERIMENT
� Tripod
For image recording tripod for the camera was always used, to reduce blur of applied long
exposure time. Shutter time was also set for 0,5sec, to avoid camera movements and then blur
while touching the camera.
The best pictures were taken, with additional lights and without flash and these were chosen
for processing. In PhotoModeler Scanner a few photos with dust were used as well, to
compare the results. Figure 4.1 illustrates one of the photographs taken during image
acquisition. It is possible to see that the photo is quite good; but it was not possible to avoid
reflectiveness of shiny material and some pixels are “lost” (too bright, sometimes too dark).
Additional control point around and on the sculpture were used for better bundle adjustment
results. There was also scale bar to be able to scale the project. After all, a lot of images have
been recorded and some of them may be found in folder: Canon\Photos including photographs
for camera calibration.
Figure 4.1 Photograph from image acquisition
36