c-2900-26

Feed recommendations and geometry descriptions
PARTING AND GROOVING
A
ENG
Cutting data recommendations for CoroCut® QF
Face grooving
Grooving feed
Insert width (CW), mm, inch
Turning feed
Cutting depth (a p), mm, inch
Excellent for profiling in all materials
Outstanding chip control even at low
feeds and small depths of cut.
Good surface finish.
B
-RM
Feed (f n), mm/r, inch/r
Feed (f n), mm/r, inch/r
0.6 0.7
.024.028
C
-GF
Grooving feed
Insert width (CW), mm, inch
For precision grooves
Good accuracy and repeatability due to
tight tolerances on inserts.
Low cutting forces and good surface
finishing due to sharp cutting edge.
D
Feed (f n), mm/r, inch/r
Grooving feed
Turning feed
Insert width (CW), mm, inch
Cutting depth (a p), mm, inch
-TF
Feed (f n), mm/r, inch/r
Feed (f n), mm/r, inch/r
Cutting data recommendations for CoroCut® 1-2
Profiling
First choice geometry for face grooving
Our most universal geometry for face
grooving in all materials.
Positive geometry gives low cutting forces
and good chip control.
Good surface finish thanks to wiper
design.
Generates flat bottom grooves.
E
F
-RO
Turning feed
Cutting depth (a p), mm, inch
Excellent for profiling in stainless steel,
HRSA and other sticky materials
HRSA and other sticky materials.
Outstanding chip control at low
feeds and small depths of cut.
Good surface finish. Sharp cutting edge.
Available as CoroCut 2-edge inserts.
G
Feed (f n), mm/r, inch/r
H
= Recommended starting value.
PARTING AND GROOVING Feed recommendations and geometry descriptions
B 137