c-2900-26

A
PARTING AND GROOVING
Feed recommendations and geometry descriptions
Cutting data recommendations for CoroCut® 1-2
ENG
B
Grooving
Radial feed
Insert width (CW), mm
Axial feed
Cutting depth (a p), mm
Allround geometry for grooving with low
feed in most materials.
Periphery ground with sharp cutting
edge.
123-GS
C
Low feed choice Feed (f n), mm/r Feed (f n), mm/r
123-S
Radial feed
Insert width (CW), mm
Alternative for finish grooving of
hardened materials and heat resistant
super alloys
Maintains close tolerances and gives
excellent finish on components.
Available as CoroCut 1-edged inserts.
D
Cubic boron nitride
tipped
Feed (f n) mm/r
E
Profiling
Radial feed
Insert width (CW), mm
Axial feed
Cutting depth (a p), mm
Excellent for profiling in all materials
Outstanding chip control even at low
feeds and small depths of cut.
Good surface finish.
Available as CoroCut 1 and 2-edged
inserts.
123-RM
Medium feed choice
F
Feed (f n) mm/r
Feed (f n) mm/r
G
123-RO
Radial feed
Insert width (CW), mm
Axial feed
Cutting depth (a p), mm
Excellent for profiling in stainless
steel, HRSA and other sticky
materials
HRSA and other sticky materials.
Outstanding chip control at low feeds
and small depths of cut.
Good surface finish. Sharp cutting
edge.
Available as CoroCut 2-edge inserts.
H
Feed (f n), mm/r
= Recommended starting value.
For cutting speed recommendations, see page B130
Feed (f n), mm/r
PARTING AND GROOVING Feed recommendations and geometry descriptions
B 140