electrical data - Mitsubishi Heavy Industries

Details of operation control
(1) Flap control
30
SRK-H
Control the flap by the flap button on the wireless remote control
(a) AUTO (Natural flow)
The flap will be automatically set to the angle of air flow best to operation mode
1) Starting time of operation
In case of cooling and
In case of heating
sdry operation t soperation t
Stops at the level
position for one minute.
2) When not operating
(b) Memory flap
Sway operation
¡The flap operation as shown above
will repeated.
Sway operation
¡ When the room temperature controller (thermostat)
is activated, horizontal blowing is applied
to prevent cool wind from blowing out.
Air flow when flaps are used
downward in heating
The flap returns to the position of air flow directly below, when operation has stopped.
Warm are naturally rises.
Warm air is sent to the floor, creating the ideal room temperature
variation is created in which the feet are warmer and
the air around the head slightly cooler.
While the flap is operating if the AIRFLOW button is pushed once, it stops swinging at an angle.
As this angle is memorized in the microcomputer, the flap will be automatically set to the angle when next operation is
started.
¡ Recommendable stopping angle of the flap
(c) Swing flap
COOL . DRY Horizontal
blowing
Stops at the position
for three minutes
and fifty seconds
Flap moves in upward and downward directions continuously.
HEAT
Slant forward
blowing