Marca Model Difetto Cura Aim AR276 Stops aft 10 mins R443 6R8 ...

Hitachi VTF150 Play not working Half load arm spring broken - not available separate
Hitachi VTF150 Squawk only at power on Zener D9 s/c & C16 hi esr
Hitachi VTF150 Tape runs slow & grinding noise C12 & C13 470µ 16v in psu
Hitachi VTF150E Capstan motor labours, Rfo/p flickers upon tape insertion Replace C12 470µ 16v, C34 & 35 4µ7 35v,
Replacing capacitors C6, C34, C35, C12, C13, C15, C23, C11, T1.6 fuse and a new
Hitachi VTF150E Dead
pinch roller had this fixed.
Hitachi VTF150E Dead µ 250v cap in psu pri, 18v zener in psu sec s/c & check caps in sec
No -30v pin 3 psu connector. Dry joints on chopper transformer (where the wires are
Hitachi VTF150E Dead - no display or mechs
connected to the legs - not the pcb conns)
paint peeling off supply reel interfering with reel pulses - replace reel pt no 6416631 &
Hitachi VTF150E Ffwd/Rew slow
TU reel pt no 64166651
Hitachi VTF150E scrambled pic in e-e - ok on scart replace electrolytic caps in if can
Hitachi VTF150E Sound on Pback has wow & E-E pic flickers Ripple on V-Capst o/p - C12 & C13 470µ faulty
HITACHI VTF150E SOUNDS LIKE FAULTY CAPSTAN MOTOR REPLACE C12 AND C13 IN POWER SUPPLY 470MFD16V (2)
Hitachi VTF250 Capstan motor noisy - also eject may be affected C12 470µ in A14V supply
HITACHI VTF250E SOUNDS LIKE FAULTY CAPSTAN MOTOR REPLACE C12 AND C16 IN POWER SUPPLY 470MFD16V (2)
Hitachi VTF350 Int stops in rec, int lines, dist sound etc replaced all electro caps in psu
Hitachi VTF350 noisy capstan motor C12 470µ in psu
Hitachi VTF350 Play runs slow tho' replacement capst motor fails to cure
won't accept tape when cold & screeching noise from
C12 & C13 470µ 16v in psu
Hitachi VTF350 capstan C12 470µ 16v o/c also check C16 & C11
Hitachi VTF350E No display & vcr goes straight in to play then shuts off No -30v supply pin 3 of psu conn. R36 68R fusible 1/6w o/c also change C15 10µ 50v
Hitachi VTF350E R/C int - not Hset Resolder joints to main pcb at PG951 front panel link
Hitachi VTF360 Dead C's 0865, 0874, & 0871 all 47mfd 63v hi esr
Hitachi VTF360 Int failure to eject tapes loading motor chip BA6209 dry joint
Hitachi VTF360 Int sigs from tuner Dry joints IF/tuner
Hitachi VTF360 Int slack tape on eject Mode sw
Hitachi VTF360 Plays for a few secs then stops Change elects in PSU (may read ok on esr meter) - PSU difficult to access
Hitachi VTF360E int e-e & pback sound int conn at earth return at head amp/ audio panel pcb conn to main pcb
Hitachi VTF360E Int no control tracks recorded & tape edge damage Back tension band pad had parted company
Hitachi VTF360E Sluggish eject & slow pback Check capstan motor clutch
Hitachi VTF450 Dead QF901 N5 cct prot o/c 250mA
Hitachi VTF450 Dead, no display, psu tripping Cap 47µ 63v on live side of psu next to chopper heatsink