Marca Model Difetto Cura Aim AR276 Stops aft 10 mins R443 6R8 ...

LG W201 To set RF o/p freq
In power off mode with display on press Prog up & Prog down buttons together for 5
secs until "RF-CHnn" shows. Press Up/down buttons to change chan.
LG W209i Erase int Change C403 from 0.022µ to 0.015µ
LG W906 When operated goes into st/by after capst rev shuffle F106 N20 cct prot on main pcb under mechs o/c
LG W9061 Modulator adj
LG W9061 RF setup
In st/by hold chan up & down buttons on vcr for 4 seconds until display changes to UHF
chan no. (Default = Ch22) Using chan buttons adj to req freq then press st/by to bring
vcr on & store new freq.
put machine into stby then hold down the Chan+and - buttons together until CH22
appears in the display then use Chan +/- keys to alter o/p freq, then press power button
to store.
LG W9311 No action - no LED lit at sw on - comes on when re-pressed F106 IC prot o/c under RH side of deck
Put vcr into sleep mode (press st/by twice) wait till the display fades then press P+ & P-
LG W9311 RF output adjust
together. Storing is automatic
F106 N20 CP on main pcb o/c - beware of stray light when operating machine with
LG W931I No mech functs tape stuck, in alarm mode "< >"
cover removed
Lloyds L444 (Sharp) "00" in display only with flickering & no functs 3300µ 25v cap in psu
Logik VR945 Dead - no 5v to micro pin 32 D515 on main pcb going high res
Logik VR950 Hum from PSU in Rec, Play & E-E C7 2200µ 63v
Logik VR955 No col in Pback & e-e missing W2 link on psu feeding unreg 18v had corroded thro
Logik VR960 Dead STK5332
Logik VR960 Display lights but no actions ICP201 oc
Logik VR960 No mech functs - clock ok IC6101 LA6358
Logik VR960 Pulling pic on pback Entry guide pole adj
Logik VR960 Wont switch on or off Q506 2SD734
Matsui TV161 control track problem noise band every 10sec one of phases on drum motor odd - res check proved 1 coil o/c
Matsui TVR141 E-E no sound poor joints on the main pcb in the video section
Matsui TVR141 Pback slow excess back tension - clean back tens band and supply reel
Matsui TVR141 tracking bars, slow sound on pback ripple on AT5.6v line - C523 100µ 16v on tv chassis
Matsui TVR161W No Drum rotation Dry joints on deck connector CP1001 also clean mode switch with fibre pen.
Matsui TVR162 Noise band 1" high at bottom of pic Check guide arm mountings - tend to be flimsy and break
Play a known good test tape, Hold the volume down on the set and press number 3 on
Matsui TVR180 Head Switching point adj (disturbance at bottom of pic) the handset - it should "sort itself out"
Matsui TVR180 Stuck in st/by Get pre-prog EEPROM 24C08 from Grandata
resolder socket pins on drum motor pcb, some used as print through links for double
Matsui TVR185 Drum speed erratic, sometimes stopping
sided pcb