C80prox Marklin Digital Control Program for PC's

More documents

Recommendations

Info

C80prox – Marklin Digital Control Program for PC’s general format is: d m {mm} where {mm} is the module number (1 to 31). The display will continually update until an ESC key is pressed. The contents of the module will be erased after each read. If {mm} is not specified, all defined TDM's will be displayed. Page 18 Version 1.1 October 16, 2003
C80prox – Marklin Digital Control Program for PC’s Other Commands Most of these commands can be used in Terminal Mode or used when creating and running a sequence using the C80prox Editor. Sleep Function This command will sleep for the specified number of seconds. The general format of this command is: z {tt} p {tt} p w where {tt} is the number of seconds to sleep (1 to 99). When used in a layout sequence, the sleep command can be used to wait a few seconds before the next command is issued. The sleep function can be interrupted by pressing the ESC key. Control will then pass back to TERMINAL MODE. The 'p' command functions the same as the 'z' command except that {tt} defines the number of 1/10th second intervals to sleep. The 'pw' command will pause and wait for any key to be pressed before continuing. Goto Function This command is used to start a layout sequence from the specified label. The general format of this command is: g {ll} where {ll} is a valid label within the layout sequence. If {ll} is not specified in TERMINAL MODE, execution will start at the first statement in the sequence. While a sequence is running, there are two keys that can be pressed. These keys are • 'F10 - emergency stop' • 'ESC - quit to terminal mode' A statement label must be used as a argument to a 'g' command. Statement labels are defined by placing a ':' after a numeric label between 1 and 1000. An example of this style of branching is as follows: 1: 10: 2: .. 3: .. 4: .. 5: g 10 Branching Randomly Within a Sequence This command is used as a random multi-way goto function. The general format of this command is: g r {b} Page 19 Version 1.1 October 16, 2003
Page 1 and 2: C80prox Marklin Digital Control Pro
Page 3 and 4: C80prox - Marklin Digital Control P
Page 17: C80prox - Marklin Digital Control P
Page 39: C80prox - Marklin Digital Control P

C80prox Marklin Digital Control Program for PC's

Create successful ePaper yourself

Delete template?

Save as template?